En 10002-5

The faster, easier way to work with standards. In the absence of sufficient data on all types of metallic materials it is not possible, at present, to fix values of uncertainty for the different properties measured by tensile test. Caution the offer 1 user is reserved for a single user, any broadcast even within his company is prohibited. Iron and steel products. Already Subscribed to this document.

Uploader: Brazil
Date Added: 28 September 2016
File Size: 22.74 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 93368
Price: Free* [*Free Regsitration Required]





Methode d'essai a temperature elevee Title in German Metallische Werkstoffe. Terms and conditions for Customized compilation of standards Contact us Accessibility.

However, products of constant cross-section and as cast test pieces may be tested without being machined. In particular, a distinction is made between: It is also possible to switch between metric SI and Anglo-Saxon units with one click depending on your preference.

Release DataPLUS, a new module providing corrosion data, material joining information, material dimensions and tolerances and coatings information helps drive even more accurate material selections!

BS EN - Tensile testing of metallic materials. Method of test at elevated temperatures

Iron and steel products. The symbol used is followed by the suffix giving the prescribed percentage, such as R t0,5 permanent set strength R r - stress at which, after removal of force, a specified permanent elongation or extension expressed respectively as a percentage of the original gauge length L o or extensometer gauge length L e has not been exceeded fracture - phenomena which is deemed to occur when total separation of the test piece occurs or force decreases dn become nominally zero Symbols and designations 1002-5 and corresponding designations of the test piece are given in table 1.

R m MPa Tensile strength On the Figure 2 schematic definitions of elongation are given. This standards consists of five parts: Select the first category of products searched and follow the instructions. The faster, easier way to work with standards. R p MPa Proof strength, non-proportional extension You may experience issues viewing this site in Internet Explorer 9, 10 or Property Data This page displays only the text of a material data sheet.

Please read our License Agreement regarding materials data and our Privacy Policy. Dynamic Strain Aging of Steels: R eH MPa Upper yield strength Annexe G informative Bibliographie As the voice of the U.

Tensile Testing Of Metallic Materials :: Total Materia Article

Or if you don't have an account with us yet, then click here to register. Register online at inter and intra-company training, and certifying diplomas, seminars, distance learning.

We have no document history for this standard.

In the absence of sufficient data on all types of metallic materials it is not possible, at present, to fix values of uncertainty for the different properties measured by tensile test.

Gas Nitriding of Titanium Alloys: R r MPa Permanent set strength Drift-expanding test ISO 01002-5 More information add to basket.

МКС EN 10002-5:2009

S u mm 2 Minimum cross-sectional area after fracture - k - Coefficient of proportionality Click on the material of interest. Legal notices Photo credits FAQ. Diameter of the parallel length of a circular test piece, or diameter of round wire or internal diameter of a tube.

We use cookies to make our website easier to use and to better understand your needs. Symbols and designations for different types of strength Reference Figure 3 Symbol Unit Force and strength

4 thoughts on “En 10002-5

  1. I can not participate now in discussion - there is no free time. I will return - I will necessarily express the opinion on this question.

Leave a Reply

Your email address will not be published. Required fields are marked *